Clik here to view.
lib-iio and gr-iio instalation error with pybombs
hi,I'm getting this error trying to install the libiio and gr-iio with pyboms (with command sudo pybombs install gr-iio): [ 4%] Building C object...
View ArticleHow to change GAIN_CONTROL_MODE on ADALM-PLUTO?
Hello,Every one, I want to know how to chang RX_gain_control_mode on ADALM-PLUTO?
View ArticleClik here to view.
Pluto error in gnuradio. WARNING: Unknown children 'context-attribute' in
Running iio_info gives me this. root@debian:~/prefix/default# iio_info -n 192.168.2.1 | grep deviceWARNING: Unknown children 'context-attribute' in <context>WARNING: Unknown children...
View ArticleWhen will the ADALM-PLUTO be back in stock?
When will the ADALM-PLUTO be back in stock?
View ArticleClik here to view.
Automating the firmware build a couple of questions re versions and the...
I am trying to setup an autobuild so I can produce a modified firmware for the ASDALM-PLUTO. Most of what I am doing seems to be working fine except for two puzzle areas. 1. The VERSIONS file is...
View ArticleIn Pluto SDR, PL reprogramming from Linux crashes IIO streaming
Hello My name is Danil.I am very excited about the new Pluto SDR, it works very well.I'm actually working on my own custom PL image for Pluto SRD and want to replace original system_top.bit. I want to...
View ArticleHow to autoload my program on ADALM-PLUTO?
Hello everyone,I had wrote a test program "hello world" that was load on PlutoSDR by tftp. This program can run on ADALM-PLUTO.Now I want to put this program onADALM-PLUTO.Next the system power on,this...
View ArticleAdalm Pluto Transmit Data via Libiio in C++
I'm having some trouble transmitting data from my pluto, as far as I can tell it's not being modulated onto the carrier wave but is being sent to hardware. I can get samples from the pluto so wanted to...
View ArticleAdalm-Pluto in GNU
I am trying to get the adalm-pluto to work in gnu but I am having some difficulties. How do I get the blocks for it to appear in gnu? I have followed the available instructions on ADALM-PLUTO for End...
View ArticleClik here to view.
ADALM-PLUTO's driver can't be installed.
ADALM-PLUTO's driver can't be installed.[Device Install Log] OS Version = 6.1.7601 Service Pack = 1.0 Suite = 0x0100 ProductType = 1 Architecture = amd64[BeginLog][Boot Session: 2017/09/12...
View Articledetect over/under-runs gnuradio with pluto
Hello,I would like to know when an under/over-run occurs in gnuradio with pluto source and sink blocks while running. I know this is easy with UHD but with libiio I see nothing in console and I know...
View ArticleMax throughput with pluto devices as standalone device
Hello,the usb give us a max trougthput between 24-21MB between the host and the pluto device for this reason we have a limit capture sampling rate. but what happens if we capture signal directly in...
View ArticleClik here to view.
Hardware setup test of ADALM-PLUTO SDR fails during Radio Connection test
I've installed drivers, adalm firmware, hardware support package to use adalm pluto with Matlab and Simulink, but during Hardware Setup at step which check radio connection and test connection, the...
View ArticleThe pluto-sdr tx and self rx,but the frequency in the iio is strange?
Please look at the file attached;In the file test1.png,the tx freq and the rx freq is same,both are 409MHz,the ant of rx and tx both on the board;In the IIO Info say the DC is 409M,I think this is good...
View ArticlePluto SDR v0.23 shows 'write error' for 'cat ./top.bit > /dev/xdevcfg'
HelloI'm using PL reprogram in Pluto SDR v0.21 and v0.22 without any problems:cat ./system_top.bit > /dev/xdevcfgRecently I upgraded to Pluto SDR v0.23 firmware and now I can't reprogram PL part...
View ArticleClik here to view.
Pluto SDR v0.23 firmware rebuild gives '/dev/loop7' errors
Hello I'm trying to rebuild PlutoSDR firmware v0.23 from original github without any modifications.Release v0.23 · analogdevicesinc/plutosdr-fw · GitHubI do all as in 'Build Instructions' and I have...
View ArticleADALM-PLUTO experiment with the FPGA
Having the built in FPGA, this would be a great platform for learning some basic stuff about that. It would be really great if there was a tutorial on how to blink an LED with the FPGA in ADALM-PLUTO....
View ArticleClik here to view.
Generating CW Tones with Pluto in Matlab
I'm wondering if anyone can help me understand some apparent anomalous behavior of the Pluto SDR when used in conjunction with Matlab. First of all, let me say that my device seems to work just fine,...
View ArticleClik here to view.
ADALM PLUTO Antenna Performance
For anyone wondering what the resonant frequency of the antennas that come with the ADALM PLUTO kit is, I did a quick characterization using a spectrum analyzer with a tracking generator and a Mini...
View ArticleClik here to view.
Python inside ADALM-Pluto (PlutoSDR)
Hello all I want to share my experience how to use Python inside ADALM-Pluto. Python installation:(1) Download Python-2.7.3.tar.gz from rankeney user's message hereAdd python (or any rpm) on Petalinux...
View Article