ADALM-PLUTO sample rate
How do I increase the sample rate beyond 2.5M samples/sec? I modified the ad9361-iiostream.c exmample to change the RX center frequency, bandwidth, and sample rate. However, when I subsequently run...
View Articlelibiio callback
Could someone explain how actually the callback feature in libiio works?More precisely what a "sample slot" is? What I am trying to do is generate a "sample low water mark" from libiio asmy application...
View ArticlePluto usb-OTG support & shell scripts
Hi I'm looking for some more info regarding using the Pluto as a remote stand alone radio. Specifically if support exists for the pluto to interact with basic usb sensors (light, temp etc). Is there...
View ArticleADALM 2000 Questions
(Q 1) Is it possible to connect ADALM 2000 to any external instrument given that it is a software defined instrument board? (Q 2) Since it is a Software Environment hence how to tune any Instrument...
View ArticleTuning ADALM-PLUTO beyond the 325-3800MHz range
Our application requires receiving RF signals below 325 MHz. However, according to the advertised feature of ADALM-PLUTO and the RF transceiver the device uses (AD9363), it is only capable of tuning...
View ArticleAre there differing response times for various Photo Diodes?
I am trying to build a LiDAR experiment utilizing the Time-of-Flight technique. Doing so requires advanced timing circuitry in the sub-nanosecond range. One of my concerns is the response time of the...
View ArticleCybersecurity and Analog Systems
It may not sound logical, but Cyber and analog are being mentioned at the same time, in some circles. I am not an electrical engineer and know enough about analog to be dangerous. What I am looking for...
View ArticleFilter scaling
In the AD e-book EDCh 8 (http://www.analog.com/library/analogDialogue/archives/43-09/EDCh%208%20filter.pdf) diagrams of example filters are given at pages 8.31 - 8.41. Page 8.29 tells what to do to...
View ArticleClik here to view.
Failed to build v0.29
Hello ADI I'm trying to build PlutoSDR firmware v0.29, but I don't have arm folder in my /opt/Xilinx/SDK/2017.4/gnu.I only have aarch32, aarch64, armr5, microblaze folders. I'm using your "Build...
View Article