Clik here to view.
ADALM2000 case
Sorry for posting this here but I've tried contacting Robin Getz regarding the case for the ADALM2000 but there seems to be a problem with email. Robin replied in my other thread to say he's replied to...
View ArticleClik here to view.
ADALM-PLUTO SDR using one device to transmit and receive
Hello, I have been using the Pluto SDR with MATLAB (simulink). I want that in one simulation the device will transmit for a few seconds. after than it will stop the transmission and then the device...
View ArticleADALM-PLUTO serial connection
My aim is to talk to ADALM-PLUTO via a Micro Controller using the standard Serial commands.I have tested all the commands first by using Putty and then a vb.net and everything works fine.The small...
View ArticleClik here to view.
Will it be possible to feed in a reference clock to the ADALM-PLUTO?
I'm interested in whether it would be possible to use the ADALM-PLUTO time-of-arrival localization. This requires a very stable clock. I wonder whether it will be possible to feed in an external...
View ArticleClik here to view.
ADALM PLUTO Antenna Performance
For anyone wondering what the resonant frequency of the antennas that come with the ADALM PLUTO kit is, I did a quick characterization using a spectrum analyzer with a tracking generator and a Mini...
View ArticleADALM-PLUTO sample rate
How do I increase the sample rate beyond 2.5M samples/sec? I modified the ad9361-iiostream.c exmample to change the RX center frequency, bandwidth, and sample rate. However, when I subsequently run...
View Articlelibiio callback
Could someone explain how actually the callback feature in libiio works?More precisely what a "sample slot" is? What I am trying to do is generate a "sample low water mark" from libiio asmy application...
View ArticlePluto usb-OTG support & shell scripts
Hi I'm looking for some more info regarding using the Pluto as a remote stand alone radio. Specifically if support exists for the pluto to interact with basic usb sensors (light, temp etc). Is there...
View ArticleADALM 2000 Questions
(Q 1) Is it possible to connect ADALM 2000 to any external instrument given that it is a software defined instrument board? (Q 2) Since it is a Software Environment hence how to tune any Instrument...
View ArticleTuning ADALM-PLUTO beyond the 325-3800MHz range
Our application requires receiving RF signals below 325 MHz. However, according to the advertised feature of ADALM-PLUTO and the RF transceiver the device uses (AD9363), it is only capable of tuning...
View ArticleAre there differing response times for various Photo Diodes?
I am trying to build a LiDAR experiment utilizing the Time-of-Flight technique. Doing so requires advanced timing circuitry in the sub-nanosecond range. One of my concerns is the response time of the...
View ArticleCybersecurity and Analog Systems
It may not sound logical, but Cyber and analog are being mentioned at the same time, in some circles. I am not an electrical engineer and know enough about analog to be dangerous. What I am looking for...
View ArticleFilter scaling
In the AD e-book EDCh 8 (http://www.analog.com/library/analogDialogue/archives/43-09/EDCh%208%20filter.pdf) diagrams of example filters are given at pages 8.31 - 8.41. Page 8.29 tells what to do to...
View ArticleClik here to view.
Failed to build v0.29
Hello ADI I'm trying to build PlutoSDR firmware v0.29, but I don't have arm folder in my /opt/Xilinx/SDK/2017.4/gnu.I only have aarch32, aarch64, armr5, microblaze folders. I'm using your "Build...
View Article